REMOVAL, INSTALLATION AND ADJUSTMENTS
SERVICE MANUAL NUMBER 28
IMPORTANT: On Bravo One, Two and Three Models, the Trim-In Limit Insert must be
properly positioned before installing the trim cylinder anchor pin in the following
steps.
NOTE: Ensure that the Trim-In Limit Insert is reinstalled in the same position that it was in
prior to removal of the sterndrive unit. If you are not sure of it’s original position, contact the
boat manufacturer for their recommendation. Refer to “Special Information” at the front of
this section before reinstalling the Trim-In Limit Insert.
11.
Ensure that the Trim-In Limit Insert is positioned as shown for the appropriate Bravo
model.
a
75157
Bravo One and Two (Positioned Forward)
a - Trim-In Limit Insert
a
75158
Bravo Three (Positioned Aft)
a - Trim-In Limit Insert
IMPORTANT: The position of the Trim-In Limit Insert on the Bravo Three sterndrive
unit should only be changed after the boat has been properly tested. Contact the boat
manufacturer if you are not sure of the original position for a particular boat
application.
12.
Insert the aft anchor pin through the hole in the drive shaft housing.
INDEX
Page 2A-26
90-863160 MAY 2000
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | MerCruiser Sterndrives 90-863160 |
| Model Year | 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Marine readers have rated Mercury MerCruiser Bravo Outdrives Sterndrives Marine Engines Service Manual Number 28 3.0 out of 3.0 based on 1 product reviews. I could not find any mention of the seawater pump assembly.
Maybe I have the wrong unit