SERVICE MANUAL NUMBER 28
ACCESSORIES - ALL MODELS
Reassembly
1.
Press the new oil seals into the end plate/housing until the seals bottom out. The seal
lips face in the direction shown.
a
50452
a - New Oil Seals
2.
3.
4.
Wrap the diameter of the shaft (area “a,”) with masking tape to protect the seal lips.
Generously lubricate the shaft with 2-4-C Marine Lubricant with Teflon.
Lubricate the seal lips with 2-4-C Marine Lubricant with Teflon, then slide the end plate
housing onto the shaft. You may need to tap the housing into the valve guide bracket,
to seat it fully.
5.
Remove the masking tape from the shaft end.
a. Install thru-bolts, flat washers and nuts. Tighten the bolts by hand.
b. Torque the end plate bolts and copper sealing washers to 132 lb-in. (15 Nm).
c. Torque the thru-bolts to 72 lb-in. (8 Nm).
b
a
c
d
50453
50339
a - Put Masking Tape Over Shaft Diameter (Area “a”)
b - End Plate Bolts
c - Thru-bolts
d - Drive Shaft
6.
Press a new seal, lip facing out, into the seal tube, so that the seal is flush with the end
of the tube.
INDEX
90-863160
MAY 2000
Page 8A-9
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | MerCruiser Sterndrives 90-863160 |
| Model Year | 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Marine readers have rated Mercury MerCruiser Bravo Outdrives Sterndrives Marine Engines Service Manual Number 28 3.0 out of 3.0 based on 1 product reviews. I could not find any mention of the seawater pump assembly.
Maybe I have the wrong unit