SERVICE MANUAL NUMBER 30
MIE MODELS
5.
If coupling centerlines are not aligned or if coupling faces are more than .003 in.
(0.07 mm) out of parallel, adjust engine mounts.
a. TO ADJUST ENGINE UP OR DOWN: Loosen locking nut on mounts requiring
adjustment and turn adjusting nuts in desired direction to raise or lower.
IMPORTANT: Both front mounts (or rear mounts) adjusting nuts must be turned
equally to keep engine level from side to side.
c
a
b
d
70056
Typical Mount
a - Locking Nut
b - Adjusting Nut
c - Clamping Bolts And Nuts, With Lockwashers
d - Lag Bolts
NOTE: Some rear mounts have one (1) clamping bolt and nut on each side.
b. TO MOVE ENGINE TO THE LEFT OR RIGHT: Loosen clamping bolts and nuts on
all 4 mount brackets and move engine to the left or right as necessary to obtain prop-
er alignment. Loosen lag bolts (which fasten mounts to engine bed) and move en-
gine, as required. Retighten lag bolts securely.
IMPORTANT: Large diameter of mount trunnion MUST NOT extend over 1 3/4 in.
(45
mm) from mount brackets on any of the mounts.
After engine has been properly aligned, secure engine mounts.
Torque clamping bolts and nuts on all 4 mount brackets to 50 lb-ft (68 Nm).
Tighten locknut on all four mounts.
6.
7.
8.
INDEX
90-863161
SEPTEMBER 2000
Page 2B-11
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 496 CID |
| Model Year | 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 4)
Marine readers have rated Mercury MerCruiser 496 CID 8.1L Gasoline Marine Engines Service Manual Number 30 4.0 out of 4.0 based on 2 product reviews. How many openings for crankcaseventilation is there on
Merc 496 HO ?
Great down load . it was all there an more