SERVICE MANUAL NUMBER 30
MIE MODELS
MODELS WITH V-DRIVE TRANSMISSIONS
1.
Lift engine into boat and position so that enough propeller shaft protrudes through trans-
mission and output flange for propeller shaft coupler to be attached. Then install coupler
and position engine (no gap can be seen between coupling faces when butted together).
Adjust engine bed height if necessary to obtain proper alignment. DO NOT use mount
adjustments to adjust engine position at this time.
IMPORTANT: Engine bed must position engine so that a minimum of 1/4 in. (6 mm)
up and down adjustment still exists on all 4 mounts after performing final alignment.
This is necessary to allow for final engine alignment.
a
b
c
d
75534
Velvet Drive
d
c
b
50608
50608
a
Hurth 630V
a - Propeller Shaft
b - Propeller Shaft Coupler
c - Transmission Output Flange
d - No Gap Allowed
2.
3.
Ensure that all 4 mounts are still positioned properly. Fasten mounts to engine bed with
in. (10 mm) diameter lag bolts (of sufficient length) and flat washers. Tighten lag bolts
securely.
3/8
Disconnect overhead hoist and remove sling.
INDEX
90-863161
SEPTEMBER 2000
Page 2B-7
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 496 CID |
| Model Year | 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 4)
Marine readers have rated Mercury MerCruiser 496 CID 8.1L Gasoline Marine Engines Service Manual Number 30 4.0 out of 4.0 based on 2 product reviews. How many openings for crankcaseventilation is there on
Merc 496 HO ?
Great down load . it was all there an more