POWER STEERING PUMP
SERVICE MANUAL NUMBER 26
Pump Pulley Replacement
REMOVAL
IMPORTANT: Kent-Moore Tool J-25034 must be used to remove the pressed-on
pulleys used on power steering pumps. This tool has an end on it that will not
mushroom the end of the pump shaft. DO NOT use Kent-Moore Tool J-21239 to
remove these pulleys. This tool has a tapered end and will damage the shaft.
1.
2.
Install Kent-Moore Tool J-25034 on end of pulley and shaft as shown.
While holding tool with suitable wrench, turn threaded screw until pulley is removed.
a
72821
a - Kent-Moore Pulley Removal Tool (J-25034)
INSTALLATION
Install pulley, as follows, using pulley installer tool (91-93656A1), and a long straight edge:
1.
2.
Place pulley on pump shaft.
Thread stud all the way into pump shaft. Place bearing over stud. Do not use spacer from
kit.
3.
4.
Thread nut onto shaft. Thread tool shaft (and nut) all the way onto stud (threaded into
pump pulley).
Using a long straight edge (to check drive belt alignment), turn large pusher nut until
drive belt is parallel to straight edge.
Index
Page 8A-6
90-861329--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 181 CID |
| Model Year | 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(6 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM 4 Cylinder 181 cid 3.0L Marine Engines Service Manual Number 26 5.0 out of 5.0 based on 6 product reviews. Thanks for sharing this material. Helps a lot after suffering with bad mechanics. spend too much money and nothing very good
great manual, makes impossible jobs possible. without a manual you can not do the job, a must have.
Great resource. Excellent information provided.
Need help to install automate choke
Need help to instal automate choke