STARTING SYSTEM
SERVICE MANUAL NUMBER 26
11.
Remove drive and gear from planetary shaft.
b
a
c
74087
a - Gear
b - Planetary Gear Shaft Assembly
c - Drive
Cleaning and Inspection
IMPORTANT: Do not use grease dissolving solvents to clean electrical components,
planetary gears, or drive. Solvent will damage insulation and wash the lubricant out
of the drive and gears. Use clean rags and compressed air to clean components.
1.
Test over-running clutch action of drive. Pinion should turn freely in over-running direc-
tion and must not slip in cranking direction. Check pinion teeth. Check spring for tension
and drive collar for wear. Replace if necessary.
2.
3.
4.
5.
Check that brush holders are not damaged or bent and hold brushes against
commutator. Check brushes for wear; refer to “Brushes and Brush Holder.”
Inspect armature commutator. If badly grooved or out-of-round, turn down and undercut
commutator.
Inspect all roller bearing surfaces for wear. Check that bearings roll freely. If any
roughness is felt, replace bearings.
Inspect planetary gear assembly. Gears must mesh easily and roll freely with no binding.
INDEX
Page 4A-18
90-861329--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 181 CID |
| Model Year | 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(6 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM 4 Cylinder 181 cid 3.0L Marine Engines Service Manual Number 26 5.0 out of 5.0 based on 6 product reviews. Thanks for sharing this material. Helps a lot after suffering with bad mechanics. spend too much money and nothing very good
great manual, makes impossible jobs possible. without a manual you can not do the job, a must have.
Great resource. Excellent information provided.
Need help to install automate choke
Need help to instal automate choke