STARTING SYSTEM
SERVICE MANUAL NUMBER 26
Slave Solenoid Identification
Types
There are two types of slave solenoids (“standard” or “switch”) used on MerCruiser engines.
These engines use a standard type solenoid; do not substitute a switch type solenoid.
The other engines use a slave solenoid to energize the starter motor solenoid. Some model
engines use the small terminal on the “switch type” solenoid for ignition by-pass during the
starting of the engine. Because of this, be sure to use correct type of slave solenoid for re-
placement.
Standard Type Slave Solenoid
a
a
b
b
c
c
d
e
74581
Starting Position
Off Or Run Position
a - From Key Switch (12 Volts In Start Position)
b - To Ground
c - 12 Volts From Battery
d - 0 Volts From Starter
e - 12 Volts To Starter
Switch Type Slave Solenoid
b
b
e
a
g
a
c
d
c
f
74582
Starting Position
Off Or Run Position
a - From Key Switch (12 Volts in Start Position)
b - Mounting Bracket and Ground
c - 12 Volts from Battery
d - 0 Volts To Starter
e - 0 Volts To Ignition Coil
f - 12 Volts To Starter
g - 12 Volts To Ignition Coil
INDEX
Page 4A-10
90-861329--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 181 CID |
| Model Year | 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(6 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM 4 Cylinder 181 cid 3.0L Marine Engines Service Manual Number 26 5.0 out of 5.0 based on 6 product reviews. Thanks for sharing this material. Helps a lot after suffering with bad mechanics. spend too much money and nothing very good
great manual, makes impossible jobs possible. without a manual you can not do the job, a must have.
Great resource. Excellent information provided.
Need help to install automate choke
Need help to instal automate choke