H - 1 GENERAL
All electrical equipment on the Four Winns V335
models operates on 12 volts DC or 120 volts (220 volts
on 50 Hertz models) AC electrical power. The V335 is
equipped with a triple battery system along with
dockside power (including battery charger) as standard
features. Batteries are located in the engine compart-
1. Connect each of the red (positive) battery cables
leading from the battery selector switch to the
positive (+) terminal on each of the three batteries.
Refer to Figure H1.
Be sure all three red (positive) cables are
installed on the positive (+) battery terminals.
Fire or Explosion Hazard!
Electrical system parts are designed by and
manufactured to comply with the US Coast
Guard requirements to minimize risks of ﬁre
or explosion. Never substitute automotive
parts for marine parts. Automotive parts do
not provide the necessary ignition spark
2. Connect each of the black (negative) battery
cables leading to the engine block to the negative
(-) battery terminals on each of the three batteries.
DO NOT tamper with any electrical connection,
panel or harness, or attempt installation of any
electrical equipment unless thoroughly familiar
with the systems and experienced in making
Circuit breakers are installed on the battery switch to
protect various system components. The SHIP SYS-
TEMS breaker supplies power to all DC electrical
components except the aft and forward bilge pumps,
ignition, and instrumentation. Additional breakers are
located in the cabin circuit breaker panel. The circuit
breakers and fuses are labeled for amperage and use.
Figure H1: Triple Battery System
Power to the engines and all 12 volt electrical equip-
ment is controlled at the battery selector panel. On the
V335 models, separate breakers are provided on the
battery selector switch panel to protect the stereo,
windlass, forward and aft bilge pump, hatch lift, battery
outputs, and ship systems.
A helm circuit breaker panel is located underneath the
diver’s seat. These circuit breakers provide additional
protection for certain component wiring which are
identiﬁed on the panel itself.
Battery Selector Switch - Dual
H - 2 DUAL ENGINE - TRIPLE BATTERY
The battery selector switch positions for the dual
battery selector switch is as follows:
Two battery selector switches are installed on dual en-
gine, triple battery installations. This allows DC power
to be used from any of the three batteries.
“OFF” - With the battery selector switches in the “OFF”
position and the “SHIPS SYSTEMS” circuit breaker in
the “OFF” position, all 12 volt power to the boat is shut
off except to the fore and aft automatic bilge pumps,
stereo, and windlass. Always turn the battery selector
switches and the SHIPS SYSTEMS” circuit breaker
Electrical Systems - Section H
Owner’s Manual Page 67
|Categories||Four Winns Manuals, Four Winns V-Series Manuals|
|Tags||Four Winns V335|
|Document Type||Owner's Manual|
|Product Brand||Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx|
|Document File Type|
|Wikipedia's Page||Outboard Marine Corporation|
(0 votes, average: 0 out of 5)