2002 Four Winns Funship 214 234 254 Boat Owners Manual

2.
3.
Bring both handles together.  Both handles should
ride on the inner gear.
5.
Make sure the actuator is secure. If unsure, extend
the trailer tongue jack to the ground and lift (with the
jack) the car and trailer combination approximately
Open (to approximately 110°) and close handles to
ratchet.  Leave in closed position to maintain pres-
sure on line.
2"
to 4". If the ball does not disengage and remains
secured, the actuator is latched properly.
NOTICE
To prevent back injury, DO NOT PHYSICALLY
LIFT the trailer tongue when loaded.
S - 3
OPERATION
A.   Hitching Trailer
6.
7.
The locking pin, provided with the trailer, or a pad-
lock must be inserted in the locking lever hole. This
ensures the the coupler’s locking lever remains in
the locked position during towing of the trailer. Use
of a padlock will help to deter theft.
Before towing, the trailer must be properly hitched to the
tow vehicle.
Connect break-away cable S-hook securely to one
of the tow vehicle hitch’s safety  chain connection
points. The cable should hang clear of trailer tongue
and be long enough to permit short radius turns with-
out pulling break-away cable forward. DO NOT loop
the break-away cable around a bracket and loop it
back onto itself.
To ensure proper engagement of the actuator’s
coupler to the tow ball,  DO NOT use a multi-
piece ball, an incorrectly sized ball, or a worn/
damaged ball.  Four  Winns® 214 CFS IO &
OB trailers require a two inch (2”) diameter
tow ball.  A  two & five-sixteenths (2 5/16”)
diameter tow  ball is  required for the  234/
254
CFS trailers.
8.
Make sure the break-away lever is fully rotated to
the rear with the break-away catch pin securely lo-
cated under  the break-away spring.   The break-
away catch  pin  will be  in the  lever’s uppermost
1.
2.
Position actuator ball socket above ball hitch.
Lift up on  release handle fully (approximately 30
o
notch.
See Figure S12.
for a trailer with brake actuator and coupler assem-
bly) to allow the ball latch to rotate open. The handle
will remain up to indicate that it is not yet attached
to the ball.  See Figure S6.
3.
4.
Lower trailer tongue until  ball is seated or rests in
ball socket.
Close release handle.   If it  is a  trailer with brake
actuator and coupler assembly the handle will snap
to its closed position when properly seated.
Figure S12: Break-away Cable
The release handle will close freely with finger pressure
when ball is  properly seated in socket.   If the handle
does not close freely or does not snap to its closed
position properly, do not tow trailer. DO NOT force
handle into closed position, otherwise damage could re-
sult. Inspect actuator for bent parts or cause of improp-
er operation.
The Break-away system is not designed to op-
erate if the trailer does not separate completely
from the  tow vehicle,  or if  the trailer  tongue
“submarines” and  goes beneath  the tow ve-
hicle. DONOTusebreak-awaycableasapark-
ing brake.
NOTICE
Keep the coupler clean  and lubricated to pre-
vent damage to the coupler.
Candia FS Owner’s Manual
Section S
Page 8
03/00
Product Specification
CategoriesFour Winns Funship Manuals, Four Winns Manuals, Outboard Marine Corporation Manuals
Tags, ,
Model Year2002
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 139 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandBoats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx
Document File TypePDF
Publisherfourwinns.com
Wikipedia's PageOutboard Marine Corporation
CopyrightAttribution Non-commercial
(1 votes, average: 3 out of 3)
Marine readers have rated 2002 Four Winns Funship 214 234 254 Boat Owners Manual 3.0 out of 3.0 based on 1 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

2002 Four Winns Funship 214 234 254 Boat Owners Manual SKU UPC Model
marc le bourlout on Aug 21, 2018. freesbee

very good boat i need the specs


Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website