STORAGE
4)
Allow outboard to run until it shuts itself OFF automati-
cally (less than one minute).
Winterization is complete when outboard shuts itself off.
•
If the outboard DOES NOT shut itself off, you may
not have properly advanced throttle grip.
Winterization is complete when outboard shuts itself off.
•
If the engine exceeds 3000 RPM, the outboard may
• If the outboard DOES NOT shut itself off, you may
not have allowed enough running time at a throttle posi-
tion.
have been shifted into gear.
In either event, immediately press STOP button to turn
outboard OFF and re-start the procedure.
•
If the engine exceeds 3000 RPM, the outboard may
have been shifted into gear.
In either event, immediately turn key switch OFF and re-
start the procedure.
Remote Control Outboards with Foot
Throttle
1)
Press foot throttle to HALF THROTTLE position. Start
the outboard. Outboard runs at slow idle speed.
After Winterization – All Outboards
1)
After the outboard shuts itself off, turn key switch OFF.
(For tiller models, remove emergency stop clip / key
switch.) Do not start the outboard again after winteriza-
tion is completed.
2)
If winterizing on a trailer, turn off water and detach
garden hose. Grease propeller shaft splines with rec-
ommended lubricant, and re-install propeller.
IMPORTANT: When winterizing is finished, leave the out-
board in vertical position long enough to completely drain
the powerhead. If equipped, disconnect the speedometer
pickup at the upper connection and blow all water out of the
hose using air pressure of 172 kPa (25 psi) or less. Recon-
nect speedometer pickup after all the water has been re-
moved.
Foot Throttle – Typical
2)
After outboard runs for about 15 seconds, remove foot
from foot throttle and allow throttle to return to IDLE po-
sition. Outboard continues to run at slow idle speed.
3) Top off oil tank.
Extra engine oil is used during the winterization proce-
dure. Some excess oil may appear on the skeg below the
gearcase area. This is normal.
Avoid potential oil stains by placing a shop towel or suit-
able container under the propeller and skeg for the dura-
tion of the storage.
3)
After outboard runs for another 15 seconds, press foot
throttle to HALF THROTTLE position. Outboard will ac-
celerate to fast idle speed and fog itself.
39
| Categories | Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 115 hp, Evinrude 130 hp, Evinrude 150 hp, Evinrude 175 hp, Evinrude 200 hp, Evinrude BX, Evinrude CX, Evinrude HL, Evinrude HX, Evinrude MX, Evinrude PL, Evinrude PX, Evinrude SL |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 1 out of 1)
Marine readers have rated 2010 Evinrude 115 130 150 175 200 hp E-TEC PL PX SL BX HL HX CX MX Outboard Owners Manual 1.0 out of 1.0 based on 1 product reviews. OWNER OF A 2010 E-TEC 130 HP ON A WELD-CRAFT 18 FT BASS BOAT. A TOTAL WASTE OF GOOD MONEY. E-TEC IS THE WORST MOTOR ON THE MARKET. MINE OVERHEATS AND HAS LEFT ME STRANDED MANY TIMES. MAKE SURE YOU HAVE A GOOD TOW LINE IF YOU DECIDE TO BUY ONE.