Repair instructions
17.
wards carefully.
Install the cotter pins (1). Fold the ‘legs’ back-
19. Before connecting the shift cable be sure that if
the remote control moves forward, the shift cable ex-
tends from the cable housing, (i.e. cable pushes for
forward gear, pulls for reverse gear). Set the stern-
drive shift lever to horozontal making shure that it is in
the neutral detent position. Set the remote control
shift lever to neutral. Push the shift cable in as far as
possible. Using a fiber tip marker or suitable substi-
tute, mark the position of the cable at the cable hous-
ing (A). Pull the control cable as far out as possible.
Note the distance between the cable housing and the
marked postition on the cable. Push the cable into the
housing half the distance to the mark (A2). Install the
swivel onto the shift cable to the point it will attach to
the shift lever without moving the lever for attach-
ment. Install the washer and cotter pin. Bend the tabs
backwards onto the swivel.
1
2
18.
Lower the steering helmet and align the helmet
bushing with the recessed hole of the upper gear
head. Grease the attachment (2) with low temperature
grease, Volvo Penta part no. 1161417-9.
Install the attachment in the helmet bushing with the
recessed holes vertical (one hole over the other).
While moving the sterndrive slightly from side to side,
push home the attachment until it bottoms in the
upper gear head recessed hole. Install the two allen
head bolts (1).
Tightening torque: 35 Nm (25 lb.ft).
WARNING! Be sure the attachment is aligned in
the upper gear recess before tightening the allen
head bolts.
136
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok