Repair instructions
884830
1
1
2
3.
Install the needle bearings (1) and the spacer ring
5. In order to obtain the correct axial shaft clearance
there are 3 left hand threaded nuts (1) with different
steps available. Select a nut and tighten it (tightening
torque: 120 Nm (88.5 lb.ft.). Use special tool 884830
as a counter hold.
(
2) between the bearings in the lower gear and insert
the shaft in the gear.
NOTE! The needle bearings are matched in pairs and
must not be mixed up.
NOTE! Lubricate the treads to prevent the nut from
galling.
4.
Install the upper gear wheel with its calculated
6. Measure the clearance between the nut and the
bearing. The axial clearance should be between 0.1–
0.5 mm (0.004–0.020"). Should it prove impossible to
obtain the correct clearance with either of the nuts,
the bearing is probably defective.
number of shims in the gear housing. Install the nee-
dle bearings with the spacer ring in between and the
lower locking ring on the shaft.
NOTE! Carefully inspect the condition of the brass
washer and replace if necessary.
42
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok