Repair instructions
The propeller shaft
884140
884143
1
3
2
10.
Remove the conical roller bearing race in the inter-
mediate housing (if the old bearing can still be used).
Use special tools 884140 and 884143.
12. Install the oil deflector (1) and the locking ring (2)
on the gear wheel (3).
NOTE! Make sure that the two holes on the oil deflec-
tor coincide with the carrier pins (on sterndrives of ear-
lier manufacture). On sterndrives of later manufacture
a load pin acts as carrier of the oil deflector.
1
11.
Insert the bearing race on the roller bearing on the
lower gear housing and install the spanner tool
. Insert if necessary shims between the bear-
884348
ing race and the tool to prevent the vertical shaft from
moving axially. Tighten the spanner tool with two
screws and nuts.
13.
Press on the bearing race (1) on the propeller
shaft (in case it has been dismantled).
93
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok