Repair instructions
With the special tool installed, add one shim to the
shimming screw (1) and install finger tight while rotat-
ing the propeller shaft by hand. If propeller shaft
binds, repeat this step, adding one shim at a time, un-
til no resistance is felt through 360° of rotation.
3856761
NOTE! Do not attempt to rotate the propeller shaft
with any leverage devices (e.g., propellers or pliers).
This will damage the sliding sleeve and/or the shift
shoe.
After the proper amount of shims have been estab-
lished add one more shim to the shimming screw.
1
Coat the shimming screw threads with Volvo Penta
sealing compound, part no. 1161099-5, and install.
Tighten the shimming screw to 14–16 Nm (10–12
lb.ft.).
31.
Do not attempt to mount the special tool 3856761
on any raised portion or raised lettering on the shift
housing. The tool shall be mounted closed to the
housing.
32.
age.
Remove the special tool and install the shift link-
Install the special tool under the two starboard side
retaining screws, as shown.
NOTE! Alternatively the special tool can be mounted
on the port side, but after the gear shift rod is
dismounted.
72
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok