Repair instructions
885146
5.
Remove the cover over the shift mechanism.
7. Install the plastic bushings (1) in the holes (2) of
Hang a hose clamp on the sterndrive and install the
yoke on the sterndrive. Then lift up the sterndrive
and hang it in the tool 885146.
the suspension yoke.
UP
8.
Push the sterndrive forwards against the engine
primary shaft and turn the universal joint simultane-
ously to better allow the primary shaft splines to en-
ter the universal joint. A small guide in the joint facili-
tates the finding of the correct position.
NOTE! Install the bellow with the “UP” marking up.
6.
Push the shift cable as far into the sterndrive as
to allow the locking to lock the cable in its groove in
the cable cover. Tighten the locking plate with the 2
stainless steel screws. Key width 11 mm.
133
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok