Trim system
8.
After all adjustments are made, tighten the trim
sender bracket hold down screw. Be sure the sending
unit does not move when the bracket is tightened.
The power trim pump
The parts illustrated are those available as replace-
ment parts or complete assemblies. The following in-
structions cover the replacement of parts making up
the trim pump unit.
1
2
3
Motor assembly
Motor, incl. mounting studs
Coupling
4
O-ring
5
6
Adapter and basic pump assembly
1)
Filter
7
8
9
10
Reservoir assembly
Reservoir seal
Reservoir cap
Reservoir
11,12,13
14
Screw, spacer, O-ring assy
Thermal relief valve
1)
15
16
High pressure relief valve
1)
Low pressure relief valve
1)
A B C Original factory fitted valve assy
1)
Non-serviceable part. Replace as complete unit.
Note! Do not disassemble the valve or adapter as-
semblies, as this will disturb the factory settings and
may cause pump malfunction.
WARNING! Use great care when working with
this hydraulic system. Be sure your work area is
clean. Do not allow dirt to enter the system. Use
lint-free rags. Fill with clean recommended oil
only.
155
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok