Repair instructions
14.
Install the retaining pawl in the yoke and place the
12.
Press in both sealing rings. Use special tool
yoke with the retaining pawl in its location in the inter-
mediate housing.
884259
.
NOTE! The sealing rings are to seal against water
NOTE! Insert the wear washer (1) between the lower
attachment of the yoke and the intermediate housing
and the two plastic washers (2) with one on each
side of the bearing. Then press in the steering spin-
dle until the collar bottoms. Be very careful during the
installation of the steering spindle in order to avoid
damaging the lower sealing ring.
and thus have to be installed ”facing” each other.
13.
Glue the bushing to the yoke.
Use bushing installation adhesive, Volvo Penta part
no. 11161351-0 or Loctite 603 . The flange must be
turned downwards against the retaining pawl.
®
15.
Install the hose connection with its gasket on the
yoke. Coat the sealing surfaces with sealing
compound, Volvo Penta part no. 1161099-5 or
®
Permatex no. 3.
NOTE! On sterndrive model 280 the hose connection
must be pointing straight forwards.
76
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok