Repair instructions
Reconditioning the lower gear,
models 280-DP, 290-DP and DP
885192
Disassembly
1.
Clean the sterndrive externally.
9992520
4.
Install the suspension fixture 885192 in stand
99922520
and brace the lower unit in the stand.
1
2.
Drain the oil by removing the screw (1), if not al-
ready drained in previous steps.
NOTE! Place a drain pan under the sterndrive. Tilt the
sterndrive all the way down to allow all the oil to drain.
3a. Models 280-DP and 290-DP: Remove the lower
gear from the intermediate housing (7 screws).
5a. Models 280-DP and 290-DP: Take care of the
spline sleeve (1), the oil strainer (5) and the -ring (2).
5b. Model DP: Remove the spline sleeve (1) and the
O-rings (2 and 3). Remove the spacer sleeve along
with the O-ring (4) and the oil strainer (5).
3b. Model DP: Remove the shift mechanism cover
and remove the 5 bolts holding the lower unit on the
intermediate housing. (Two bolts are inside the shift
mechanism cover.)
6.
Remove the two screws holding the anode to the
lower unit.
99
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok