Volvo Penta MD11C D MD 17C D Workshop Manual

74.
Place the  engine so that  it is resting  on the fly-
wheel. Make  sure that the  inner thrust washer  is
correctly located.  Place the  outer thrust  washer
on the  crankshaft with  the flat surface  towards
the main  bearing. Fit the  distance washer with
the flat  surface toward the  thrust washer.
71.
Fit the  starter motor and  the oil pump.  NOTE!
Put a  little oil into  the pump before  fitting.
MD11: Fit  the front  engine brackets.
FLYWHEEL
72.
Fit the  key and the  flywheel (the taper must  be
75.
Fit the  key for the  crankshaft drive.  Heat the
gearwheel to about 100°C  (212°F) and fit it onto
the crankshaft.  Check to  make sure that  the in-
ner thrust  washer does not  move from its  cor-
rect  position.
perfectly clean).  Tightening torque 500  Nm (50
kpm =  369 lbf.ft). Lock  the nut by  bending up
the washer.
TIMING GEAR
73.
MD17: Smear  both thrust washers  with grease
and place one  of them on the  inner side of the
bearing shield,  turning the flat  side towards the
main bearing. Ensure  that the lug on  the washer
fits into  the recess in  the shield.  Fit the bearing
shield onto  the engine and  tighten the screws.
76.
Fit the  camshaft and ensure  that the oil  pump
shaft fits  into the  slot in  the camshaft.  Lock the
screws with  the lock  washers. MD17: Note  the
location of  the oil  passage.
25
Product Specification
CategoriesVolvo Penta Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 48 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(2 votes, average: 4 out of 5)
Marine readers have rated Volvo Penta MD11C D MD 17C D Workshop Manual 4.0 out of 5.0 based on 2 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

Volvo Penta MD11C D MD 17C D Workshop Manual SKU UPC Model
petar ognyanov on Jun 02, 2014.

I realy need it!!!


pauli tuovinen on Oct 31, 2012.



Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website