Volvo Penta MD11C D MD 17C D Workshop Manual

Assembling
Use new  gaskets, sealing  rings, sealing washers  and
lock washers.  Grease or oil the  sealing rings and  oil
moving parts  before  fitting.
CRANKSHAFT
68.
Fit the  crankshaft in  the crankcase.  Ensure that
the hole for  the centre bearing  locating screw
lines up  with the hole  in the crankcase.  MD11:
Make sure  that the lug  on the thrust  washer fits
into the  recess in  the crankcase.
66.
Fit the centre  bearing (or bearings) on  the crank-
shaft. NOTE!  Turn the bearing  the right way
round so  that the locating screw  in the crank-
case fits into  the hole (2)  in the centre  bearing.
69.
Replace the O-ring  on the centre bearing  locat-
ing screw.  Wind-on a little thread-sealing  tape
and apply  Permatex to the  outside. Screw  the
locating screw  in so that  it bottoms  properly and
then loosen  it by half a  turn.
“1”
oil passage, “2”  hole for locating  screw.
70.
MD11: Replace both  O-rings on the bearing
shield, see  illustration.  Replace the  crankshaft
sealing ring.  Stick a small  piece of  tape over the
keyway in  the crankshaft and  fit the  bearing
shield.
67.
MD11. Smear  the two thrust  washers with
grease and  fit one of them  on the crankshaft
turning the flat  side towards the rear  main bear-
ing (timing  gear side). The other  washer is fitted
in point 74.
MD17: Stick  a small piece  of tape  over the key-
way in  the crankshaft and fit  a new sealing  ring.
24
Product Specification
CategoriesVolvo Penta Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 48 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(2 votes, average: 4 out of 5)
Marine readers have rated Volvo Penta MD11C D MD 17C D Workshop Manual 4.0 out of 5.0 based on 2 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

Volvo Penta MD11C D MD 17C D Workshop Manual SKU UPC Model
petar ognyanov on Jun 02, 2014.

I realy need it!!!


pauli tuovinen on Oct 31, 2012.



Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website