detent. A double horn chirp indicates a”throttle only”
is engaged. The neutral light will also begin to flash.
Move the shift/throttle lever forward to increase engine
RPM. Note: Engine RPM is limited while in “throttle
only” mode to prevent engine damage. To disengage,
return the shift/throttle lever back to the neutral
position. To move the levers to the desired positions
after starting you simply push or pull the shift/throttle
levers. See the manufacturer’s literature for further
details.
NOTICE
Failure to move the throttle handle to the idle
position immediately when engine starts will
allow engine to “over-rev” and engine damage
could result. “Over-revving” engine after off-
season storage could also damage the water
pump impeller. When starting engine for the
first time after off-season storage, always
idle engine for ten minutes to allow the
water pump to prime.
NOTICE
NOTICE
When starting engine for the first time after
off-season storage, always idle engine for ten
minutes to allow the water pump to prime.
Priming is not necessary for EFI engines.
Refer to the engine owner’s manual for
additional information.
NOTICE
NOTICE
NEVER turn key to START position when
engine is running.
Priming is not necessary for EFI engines.
Refer to the engine owner’s manual for
additional information.
C. Cold Engine Starting Procedures -
Mercruiser Engines w/DTS
NOTICE
NEVER turn key to START position when
engine is running.
1.
Move the dual shift/throttle lever of the control to
the neutral gear (idle) positions. When in the
neutral position the neutral light will be illuminated.
The handle must be in neutral to start the engine.
D. Shifting and Control Speed
NOTICE
2a. For gasoline engines, turn key switch to START
position and hold until engine starts. DO NOT hold
in START position for more than ten seconds. If
engine does not start, let go momentarily, then try
again.
If your boat is equipped with a non-OEM
remote control system, ask your dealer how to
properly operate it.
1.
Move shift/throttle lever(s) to the neutral idle
position. Placing the shift/throttle levers in the
neutral detent position will engage neutral start
switch and allow engine to start.
2b. For diesel engines, you must first turn the ignition
key to the ON position and wait 30 seconds,
allowing preheaters to activate. After 30 seconds,
turn key switch to START position and hold until
engine starts. DO NOT hold in START position for
more than ten seconds.
2. To go FORWARD - move the shift/throttle lever(s)
forward. Once forward gear engagement is
complete, push shift/throttle lever(s) forward until
desired speed is achieved.
3.
As soon as engine starts, release key to the ON
or RUN position.
3.
To go in REVERSE - move the shift/throttle
lever(s) rearward. Once rearward gear engage-
ment is complete, push shift/throttle lever(s)
rearward until desired speed is achieved.
To warm up engine(s) after starting:
The “throttle only” feature allows the boat opertor to
increase the engine’s RPM for warm-up, without
shifting the engine into gear. To engage the “throttle
only”, move the shift/throttle lever into neutral position.
Depress and hold the throttle only button while moving
the shift/throttle lever ahead towards the forward
Operation - Section A
Owner’s Manual Page 20
| Categories | Four Winns Manuals, Four Winns V-Series Manuals |
|---|---|
| Tags | Four Winns V375 |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)