SERVICE MANUAL NUMBER 25
262 CID (4.3L) ENGINES
1.
Assemble piston to connecting rod using piston pin remover as shown. Follow instruc-
tions supplied with kit.
a
72897
a - Piston Pin Remover (J-24086-B)
2.
3.
Once assembled, check piston for freedom of movement in all directions on connecting
rod; piston should move freely. If it does not, piston pin bore is tight and piston/pin as-
sembly must be replaced.
If a new connecting rod has been installed, mark connecting rod and cap (on side of rod
and cap with slots for connecting rod bearing tangs) with cylinder number in which it will
be installed.
PISTON RINGS
All compression rings are marked on upper side of ring. When installing compression rings,
make sure that marked side is toward top of piston.
Oil control rings are a three-piece type, consisting of two rings and a spacer.
1.
2.
Select rings comparable in size to cylinder bore and piston size.
Slip compression ring in cylinder bore, then press ring down into cylinder bore about 1/4
in. (6 mm) (below ring travel). Be sure that ring is square with cylinder wall.
3.
Measure gap between ends of ring with a feeler gauge as shown.
72372
4.
5.
6.
If gap between ends of ring is below specifications, remove ring and try another for fit.
Fit each compression ring to cylinder in which it is going to be used.
Clean and inspect pistons.
Index
90-861328--1
NOVEMBER 1999
Page 3A-81
Categories | Mercury MerCruiser Manuals |
---|---|
Tags | Mercury MerCruiser 1262 CID, Mercury MerCruiser 262 CID |
Model Year | 1998, 1999, 2000, 2001 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
(4 votes, average: 4.5 out of 5) Marine readers have rated Mercury-MerCruiser GM V6 262 CID 4.3L Marine Engines Service Manual Number 25 Sections 1-3 4.5 out of 5.0 based on 4 product reviews.
This is great. I really like it. Thank you for providing this valuable opportunity for me.
if I can get the info that would be great
The information given is enoug .
In my opinion this is the best site on the net. Assisting people to do a job correctly and safely.