SERVICE MANUAL NUMBER 25
MCM MODELS
Installation and Alignment
1.
Inspect fiber washers (cemented in place) on inner transom plate. Replace if worn or
damaged.
2.
3.
4.
5.
Install double wound lockwashers onto inner transom plate inside fiber washer.
Ensure that rear engine mount locknuts are in position.
Lubricate exhaust bellows with soap and water to ease installation.
Lubricate engine coupler splines with Quicksilver Engine Coupler Spline Grease.
a
b
c
d
72023
a - Double Wound Lockwasher
b - Fiber Wound Lockwasher (Cemented In Place)
c - Inner Transom Plate Mount (Engine Support)
d - Locknuts (Engine Mounting Bolts)
CAUTION
Center lifting eye (located on top of thermostat housing) is used for engine
alignment only. DO NOT use to lift entire engine.
CAUTION
DO NOT allow lifting sling to hook or compress engine components or damage will
occur.
6.
Attach a suitable sling to lifting eyes on engine and adjust so that engine is level when
suspended.
7.
8.
Lift engine into position (in boat), using an overhead hoist.
Align rear engine mounts with inner transom plate mounts while simultaneously aligning
exhaust tubes with exhaust pipe hoses (bellows).
Index
90-861328--1
NOVEMBER 1999
Page 2A-5
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 1262 CID, Mercury MerCruiser 262 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4.5 out of 5)
Marine readers have rated Mercury-MerCruiser GM V6 262 CID 4.3L Marine Engines Service Manual Number 25 Sections 1-3 4.5 out of 5.0 based on 4 product reviews. This is great. I really like it. Thank you for providing this valuable opportunity for me.
if I can get the info that would be great
The information given is enoug .
In my opinion this is the best site on the net. Assisting people to do a job correctly and safely.