X INSTALLATION
INSTALLING THE OUTBOARD
WARNING
The outboard must be correctly
installed. Failure to correctly install
the outboard could result in serious
injury, death or property damage. We
your
Dealer install your outboard to
ensure proper installation.
1
1
strongly
recommend
that
IMPORTANT: Follow all directions carefully.
The outboard’s warranty will not cover prod-
uct damage or failure that results from incor-
rect outboard installation.
007999
1.
Drilled transom holes, 15 HO models
Use the supplied hardware to securely mount
Refer to Priming the Oil System on page 19. the outboard.
Install the mounting bolts through the stern
brackets and transom. Install large washers
and locknuts onto bolts and tighten securely.
WARNING
Even if equipped with clamp screws,
your outboard must be bolted to the
boat to prevent it from “working off
the transom” during operation.
Center the outboard on the transom (or
mounting bracket) and tighten clamp screws
by hand.
Use the outboard stern brackets as a tem-
plate for location and size of holes to drill in
the transom.
1
Use each stern bracket’s mounting holes as a
guide to drill 5/16 in. (7.9 mm) holes through
the transom. Drill two (2) mounting holes on
2
18961
25
15
/ 30 HP models and (4) mounting holes on
H O models.
1.
2.
Large washers
Bolts
WARNING
When replacing bolts, screws, or
other
fasteners,
use
Evinrude/
1
1
Johnson parts or parts of equivalent
strength and material.
007040
1.
Drilled transom holes, 25 / 30 HP PL models
63
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 15 hp, Evinrude 25, Evinrude 30 hp, Evinrude DEL, Evinrude DHPL, Evinrude DHT, Evinrude DPL, Evinrude DR, Evinrude DRL, Evinrude DTE, Evinrude DTEL, Evinrude HTSL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)