X OPERATION
TILLER HANDLE ADJUSTMENTS
Tiller Handle Angle
between 600 RPM and 900 RPM (approxi- Tiller handle angle can be raised or lowered
by turning the adjustment screw under the
handle.
IDLE SPEED CONTROL SWITCH
This switch allows idle speed to be adjusted
mate).
Press and release the – side of the switch to
decrease speed. Press and release the + side
of the switch to increase speed. Engine speed
changes in 50 RPM increments.
1
007020
1.
Adjustment screw
1
Tiller Handle Ratchet
007068
Tiller models feature a ratchet which holds the
tiller arm at approximately 30° or 90° posi-
1.
Touch Troll switch
This switch can be used to fine tune speeds tions. Press up on the release lever to lower
between 600 to 2300 rpm. Advance the throt- tiller arm.
tle twist grip to desired rpm. Use switch to in-
crease or decrease engine speed.
Shifting out of gear or changing throttle twist
grip position will deactivate speed control.
Stopping the engine restores the factory idle
speed setting.
TRIM/TILT SWITCH
If equipped, the trim/tilt switch is located in the
end of tiller handle. Press switch as indicated
for UP and DOWN operation.
1
1
007019
1.
Release lever
2
005107
1.
2.
Trim/tilt switch UP
Trim/tilt switch DOWN
27
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 15 hp, Evinrude 25, Evinrude 30 hp, Evinrude DEL, Evinrude DHPL, Evinrude DHT, Evinrude DPL, Evinrude DR, Evinrude DRL, Evinrude DTE, Evinrude DTEL, Evinrude HTSL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)