X ENGINE MONITORING
ENGINE MONITORING
S.A.F.E. ENGINE SYSTEM
ENGINE OVERHEATING
This outboard is equipped with Speed Adjust-
NOTICE
even for a brief start-up—without supply-
ing water to it. Refer to Flushing on page
52.
ing Failsafe Electronics (S.A.F.E.).
Do not run your outboard—
S.A.F.E. is an engine warning system con-
trolled by the Engine Management Module
(
EMM). The EMM monitors engine sensors. If
conditions which could cause permanent en- While boating, the outboard’s water intakes
gine damage exist, the EMM limits engine must stay completely submerged and unob-
speed to 1200 RPM.
structed. Observe proper transom height and
tilt angle. While the outboard is running, the
outboard’s water pump indicator must dis-
charge a steady stream of water. Check the
indicator often, especially when operating in
weeds, muddy and debris-laden water, and at
extreme trim angles.
If engine is in S.A.F.E. mode, the outboard will
shake noticeably when accelerated above
1200
RPM.
For additional protection during severe oper-
ating conditions the EMM will shut OFF the
engine.
WARNING
2
In the S.A.F.E. mode, the engine
speed is limited. Under certain condi-
tions, the engine’s limited speed may
reduce maneuverability of your boat.
If the S.A.F.E. mode is activated and
you are unable to correct the prob-
lem, seek assistance and/or return to
safe harbor. Serious engine damage,
1
engine
shutoff, and/or reduced
007031
maneuverability may be imminent.
1.
Water intake screens
The EMM activates S.A.F.E. mode for:
2. Water pump indicator
•
•
•
NO OIL warning; indicates a nearly empty
oil tank. Refer to Filling the Oil Tank and
Priming the Oil System on page 19.
OVERHEAT warning; indicates an engine
or EMM overheat condition. Refer to En-
gine Overheating on page 41.
FAULT warning; indicates a problem exists.
The EMM has identified a problem with the
outboard. Seek assistance and/or return to
harbor immediately. See your Dealer.
If the engine overheats, the S.A.F.E. (Speed
Adjusting Failsafe Electronics) mode will im-
mediately limit the engine’s speed to 1200
RPM. If the engine was running faster than
1200
RPM when the S.A.F.E. mode activat-
ed, it will shake noticeably. The protection
system must be RESET before the engine will
operate at speeds over 1200 RPM. Under
certain conditions the EMM will shut off the
engine.
41
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 15 hp, Evinrude 25, Evinrude 30 hp, Evinrude DEL, Evinrude DHPL, Evinrude DHT, Evinrude DPL, Evinrude DR, Evinrude DRL, Evinrude DTE, Evinrude DTEL, Evinrude HTSL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)