Using Your Evinrude E-TEC
To RESET the system after an overheat:
DIAGNOSTIC LEDS
•
The engine must be shut off and the cooling
temperature restored.
The Engine Management Module (EMM) has
four LED indicators located on the top corner
IF the S.A.F.E. mode activates and the of the circuit board.
stream from the water pump indicator be-
The LEDs provide quick reference to the sta-
tus of several outboard systems.
The LEDs can be used to identify specific
warning functions of S.A.F.E. mode activation
without ending a day on the water.
comes intermittent or stops, reduce speed to
idle and:
1)
2)
3)
4)
5)
Shift to NEUTRAL.
SHUT OFF the engine.
Tilt the outboard up.
Clean the intake screens of any blockage.
Clean the water pump indicator of any
blockage.
Lower the outboard.
Restart the engine and run at idle.
IMPORTANT: LED 1 is closest to the center
of the EMM.
To view the LEDs the engine cover must be
removed. Refer to Filling the Oil Tank on
page 18.
6)
7)
IF cleaning the screens and indicator does
not restore the water pump indicator’s steady
discharge, the engine will operate only in “get
home” mode. Return to harbor immediately.
See your Dealer.
IF cleaning the screens and indicator does re-
store the water pump indicator’s steady dis-
charge, you might have to run for two minutes
in NEUTRAL to allow the engine to cool.
WARNING
The engine cover and flywheel guard
are machinery guards. Use caution
when the engine is running.
DO NOT wear jewelry or loose cloth-
ing. Keep hair, hands and clothing
away from rotating parts.
NOTICE
If cooling is not restored, the
EMM will identify a progressive overheat-
ing condition and shut off the engine. The
engine will not restart until the engine is
allowed to cool.
2
3
1
After any overheat causing engine shutdown,
see your Dealer for:
•
Inspection of the water pump for excessive
wear or damage.
•
Inspection of the thermostat(s).
NOTICE
Although the S.A.F.E. mode
can help prevent engine damage, it does
not guarantee you can run your engine
indefinitely without engine damage..
007056
1.
EMM
2.
3.
LEDs
LED 1
The LEDs identify system functions in two
modes, Start Mode and Running Mode.
As the outboard is being started, all four LEDs
should light and then go OFF in sequence.
When the outboard is running, all LEDs
should be OFF.
42
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 15 hp, Evinrude 25, Evinrude 30 hp, Evinrude DEL, Evinrude DHPL, Evinrude DHT, Evinrude DPL, Evinrude DR, Evinrude DRL, Evinrude DTE, Evinrude DTEL, Evinrude HTSL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)