NOTICE
Before each use: With seat cover closed, open
and close the holding tank valve (Figure J-8)
to vent any pressure that may have built up
as a result of heat or altitude. This prevents
upward splashing of bowl contents when toilet
is flushed.
Figure J-10: Emptying Waste Holding Tank
6.
Rinse waste holding tank and recharge as
described under preparation portion of this section.
7. Reassemble unit and fasten to floor or deck.
C. Head Pump Out Option
Figure J-8: Porta Potti - Bellows Flush Operation
The waste holding tank should be emptied when
waste holding tank level gauge indicator on the porta
potti (models with pumpout option only) has changed
from green to red (Figure J-11) or when the waste
level indicator for the Vacu-flush system reads almost
full. DO NOT ALLOW THE TANK TO BECOME
OVERFILLED.
Bellows Flush Operation:
1
. Pull out holding tank valve handle (Figure J-8).
. Push down on bellows to rinse the bowl.
2
3.
Push valve handle all the way in to insure an
odor-tight seal.
Emptying of Portable Models:
Figure J-11: Porta Potti
1.
Empty when waste holding tank level appears full.
DO NOT ALLOW THE TANK TO BECOME
OVERFILLED.
If equipped with the head pump out, the waste can
be removed from the tank at a pumping station. A
deck plate fitting labeled WASTE, is provided for this
purpose. Most marina fueling facilities provide service
for waste pump out. For waste holding capacities,
please refer to the specification sheet, manufacturer’s
literature and/or our website.
2.
3.
Make sure waste valve handle is in the closed posi-
tion.
Remove fresh water tank from waste holding tank
(Figure J9).
To pump out the holding tank:
1.
Connect the dockside pump out connection to the
WASTE plate located on the deck.
NOTICE
Usually the dockside pump out connection
will screw into the waste deck plate or has a
rubber sleeve that inserts into the plate and
must be held in position during the pump out
operation.
Figure J-9: Removing Fresh Water Tank
4
. Remove waste holding tank from hold down
brackets.
5.
Carry the waste holding tank to any permanent toi-
let facility. Rotate the pour-out spout to the desired
position. Remove the cap. Depress the
air relief valve with your thumb while emptying
(Figure J-10).
2.
Have the pumping station operator activate the
pumping equipment. The waste will be drawn from
the holding tank and into the pumping stations
disposal tank.
Waste & Water Systems - Section J
Owner’s Manual Page 80
| Categories | Four Winns H-Series Manuals, Four Winns Manuals |
|---|---|
| Tags | Four Winns H |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)