On galvanized trailers with GatorHyde™, rinse all ex-
posed metal parts thoroughly with only clean water after
use. The Gatorhyde™ protective coating may cleaned
with mild dishwashing soap in a bucket of water and
nylon boat brush. Rinse thoroughly with clean water.
For more information on maintenance, refer to the
manufacturer’s literature included in the owner’s
packet.
NOTICE
The trailer should be set up at a slight angle to
allow for water to drain aft in the boat.
To rejuvenate as well as UV protect worn and faded
GatorHyde™ you may purchase a product called
GatorGloss™. To place an order you can phone
Elastomer Specialties, Inc. at 918-485-2835 or Fax
918-485-2856.
E. Winch
The winch should be kept clean of dirt, ice, paint, etc.,
and the spur gears should have a film of grease on them
at all times. Apply several drops of SAE 30 weight oil to
the ratchet pawl mechanism, bushings and pinion shaft
threads twice per season.
B. Bunks
The bunks should be replaced if they are cracked,
warped, or evidence of dry-rot is found. The replace-
ment boards should be treated lumber of the same
length and width.
Replace any worn or damaged parts. For more infor-
mation on maintenance, refer to the manufacturer’s
literature included in the owner’s packet.
F. Lights
DO NOT burn damaged or broken bunks. Toxic
fumes will be released. Dispose of bunks prop-
erly.
Inspect wiring for cuts or bare wire which could cause
electrical shorts. Repair or replace defective wiring. Re-
place cracked or damaged lens and always carry spare
bulbs. Replacement parts may be ordered through a
Four Winns dealer.
C. Swivel Jack
Keep the swivel jack clean of dirt, tar, and mud. Lu-
bricate every six months. The swivel jack’s inner ram
should be lubricated with SAE 30 weight oil. The top
cover may be removed to lubricate the gears with wheel
bearing grease.
G. Tie-downs
Replace frayed or damaged tie-downs. Periodically,
lubricate the ratchet mechanism with a fine oil or silicone
spray. Replacement parts may be ordered through a
Four Winns dealer.
Replace all worn and damaged parts. ALWAYS use the
manufacturer’s replacement parts. Replacement parts
may be ordered through your Four Winns dealer.
H. Wheels
For more information on maintenance, refer to the
manufacturer’s literature included in the owner’s
packet.
Some maintenance is required to maintain the finish
and retard rusting of painted rims. The wheels should
be cleaned with dishwashing soap and water and rinsed
with clean water immediately after each use. Waxing is
recommended three to four times each year.
D. Brake Actuator & Coupling Assembly
When storing or parking your trailer, keep the brake
actuator and coupling assembly (coupler) off the ground
to prevent dirt buildup in the ball socket. Keep the cou-
pler clean of dirt, tar, and mud. Lubricate the coupler
with SAE 30 weight oil every six months or as often as
necessary. Replace any worn or defective parts. If the
coupler is damaged, contact your Four Winns dealer for
replacement parts. DO NOT use a damaged or bent
coupler assembly.
Aluminum wheel rims may be cleaned with dishwashing
soap and water. However, clean ing products specifically
for aluminum are available and can be used. Cleaners
may be obtained from Four Winns dealers and your
local auto parts stores. The Mag wheel manufacturer
recommendsaproductbyPriorityOne® called Pro-Long
Aluminum/Chrome Wheel Protectant™. Galvanized
rims should be rinsed only with clean water immediately
after each use.
Trailer Information - Section S
Owner’s Manual Page 145
| Categories | Four Winns H-Series Manuals, Four Winns Manuals |
|---|---|
| Tags | Four Winns H |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)