To rotate the bucket seat to face the aft position:
To return the bucket seat to the bow facing position:
1
. Tilt the steering wheel (if applicable) as far forward
as possible.
1.
2.
3.
Slide the swivel seat completely forward or
rearward (as needed to clear coaming/side pad
or seat cushion) by using the lever located
underneath the seat. See Figure N-6.
2.
Slide the seat completely forward or rearward (as
needed to clear coaming/side pad or seat cushion)
by using the lever located underneath the seat.
See Figure N-6.
Locate the swivel lever on either the right or left
side of the bucket slider mechanism and lift
upward to release the pin from the pedestal. This
will allow you to rotate the seat. See Figure N-7.
3.
Depending on which bucket seat is being used,
locate the swivel lever on either the right or left
side of the bucket slider mechanism and lift
upward to release the pin from the pedestal. This
will allow you to rotate the seat. See Figure N-7.
Rotate the bucket seat inboard (towards the
center of the boat) or outboard (if applicable) until
it is in the forward facing position. Once in posi-
tion, ensure the swivel lever locks the seat in
place. Pushing down on swivel lever to lock seat
in position may be necessary. See Figure N-8.
In addition, DO NOT USE FORCE to rotate
the seat.
4
. Rotate the bucket seat inboard (towards the center
of the boat) or outboard (if applicable) until it faces
as far aft as possible or desired. Once in position,
ensure the swivel lever locks the seat in place.
Pushing down on swivel lever to lock seat in
position may be necessary. See Figure N-8.
4.
5.
Position the seat forward or aft according to the
needs of the individual by using the lever located
underneath the seat. See Figure N-6.
After rotating, ensure seat is securely locked
into position. Sudden acceleration with seat
unlocked could cause loss of balance and
possible injury.
Tilt the steering wheel (if applicable) to the desired
position using the tilt lever knob on the steering
column.
Pull lever to
up position
to rotate seat.
DO NOT sit on the backrest portion of any
cockpit seat. The operator could lose control of
boat or passengers could be thrown from boat.
Also, the seat may be damaged from improper
use.
Friction
Adjustment
Knob
E. Stern (Jump Seats)
(if applicable)
On certain standard interiors, the motorhood and two
jumpseats are installed at the stern. The jumpseats,
in the lower positions are supported by the motor hood
base and ski rack (lower upholstered pad) and/or liner.
Only on certain models can the jumpseat be placed
in an upper position to create a sunpad.
Figure N-7: Swivel Position
Once in desired
position, ensure
lever has locked
seat in place.
To install the jumpseats in the upper position
(if applicable):
1.
2.
Remove the jumpseat from the lower position.
Figure N-8: Locking Position
(Note: Representative Views Seat Sliders
may vary depending on the model).
Place the cleat of the jumpseat into the upper
recessed portion of the sidewall/coaming pad.
Upholstery - Section N
Owner’s Manual Page 99
| Categories | Four Winns H-Series Manuals, Four Winns Manuals |
|---|---|
| Tags | Four Winns H |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)