B. Starting
Passengers seated in the bow area should not
obstruct the driver’s vision.
To prevent excessive exposure and reduce the
possibility of carbon monoxide accumulation
in the cockpit areas of the boat, the operator
should provide adequate ventilation in each of
these areas. Utilize hatches, doors, windows
and side vents to increase air movement. See
Section B-2 for information about the dangers
of Carbon Monoxide.
IMPORTANT: Passengers are prohibited from riding
on the bow with feet hanging over the side or ride
while sitting on the stern, gunwales or seatbacks.
The Coast Guard considers these acts to be negligent
or grossly negligent operation. They are prohibited
by law because falls from moving boats are a major
cause of fatal recreational boating accidents.
IMPORTANT: The presence of the capacity plate
does not relieve the boat operator from the respon-
sibility of using common sense or sound judgment.
Turbulent waters and adverse weather conditions will
reduce the maximum load capacity rating of the boat.
Notice: Additional starting information is located in
Section A.
1.
2.
Check all electrical systems and navigation lights.
If your boat is equipped with an optional battery
selector switch, turn the battery switch to 1, 2, or
BOTH or ON or EMERGENCY START ONLY
position (depending on which model you have).
T - 4 STARTING PROCEDURES
The operation and maintenance manual supplied with
your engine provides pre-start, starting and cold-start-
ing instructions. The following information is merely a
guide and not intended to explain in detail all starting
procedures and instructions. Refer to your engine
owner’s manual.
3.
4.
Attach the ignition interrupt lanyards securely to
your body. In the event that you move away from
the helm area and beyond the length of the lan-
yard, the engine will be turned off.
If your boat has fuel injection, turn the key to start
the engine. Engine will not turn over if throttle is
not in the neutral position.
A. Preliminary Checks
1.
Secure boat to the dock before attempting to start
engine. The boat should be kept secure until the
engine is running and warmed up.
If your boat does not have fuel injection, depress
the engine warmup button to advance the throttle
several times and leave it in the SLOW/START
position. This will actuate the carburetor accelera-
tor pump and feed fuel to the engine. Turn ignition
key to START position.
2.
3.
Operate the bilge pump until the flow of water
stops.
Make sure the throttle is in the neutral position and
stern drive or outboard is lowered into water.
5.
6.
When engine is cold, run engine approximately
one (1) to two (2) minutes at fast idle speed (1200
to 1500 rpm). This step is not necessary with fuel
injected engines.
4.
Make sure passengers seated in the bow area do
not obstruct the driver’s vision.
Once engine has warmed up, check water temper-
ature gauge to ensure engine temperature stays
within optimum range. If temperature reading is
abnormally high, stop engine immediately and
inspect for cause of high reading.
7.
With engine running, voltmeter should show a
reading between 12 and 15 volts.
Prelaunch and Underway - Section T
Owner’s Manual Page 152
| Categories | Four Winns H-Series Manuals, Four Winns Manuals |
|---|---|
| Tags | Four Winns H |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)