1
7. Remove the main bearing caps. Take care of the axial 19. Bearing replacement. Press out the camshaft bearings if
thrust bearings 1 on the transmission side. Lift the crankshaft they are damaged or if the wear is too great (see technical
out and the bearing shells afterwards and then the axial data). Clean the bearing housings and ensure that the oil
bearing halves.
channels are clean. Press in the new bearings so that the oil
holes face the corresponding oil channels in the block. When
the bearings are pressed in position they are to be reamed
(see technical data).
Oilpump
20.
Mark the cylinder liner’s position in the cylinder so that with a puller. The gearwheel sits on a key, take care of this
Remove the gearwheel’s nuts and pull off the gearwheel
18.
the same position can be obtained during assembly.
Remove the cylinder liner. Use tool 884551. Use the long
screw and its nut from the tool 884231 (MD21-MD32). See
page 29 Special tools. Discard the 0-ring. Afterwards remove
the 0-rings in the block which provide a seal for the cylinder
liner and then remove the valve lifters. Wash all the parts
and replace those damaged.
key.
7
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta MD5A |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Volvo Penta MD5A Marine Diesel Engine Workshop Manual 5.0 out of 5.0 based on 1 product reviews. Very useful download. Thanks VM.