33.
Clean the pump housing carefully and replace worn
Crankshaft
parts. Refit the manual pump arm. Press in the diaphragm 35. Remove the circlip with circlip pliers. Then remove the
and connect the pump arm to the diaphragm centre pin. gear drive. Use a press or a gear puller. Clean the
Then push the spindle in and tighten it with the screw. Note! crankshaft and carry out control measurements of all the
Do not forget the washer under the screw.
bearing surfaces. Grind the shaft where necessary. See
Lay the gauze filter on the upper housing and screw the technical data.
cover and the gasket tight. Press in the pump arm 3,
assemble the two housing halves and fit the spring retainer 2
on the mechanical pump arm 3. Note that the spring retainer
can only be fitted one way. Replace the spring next and the
0-ring
4 which provides a seal for the engine.
Fuel filter
When the filter insert is changed the centre screw 1 is
removed allowing the filter holder to be removed. Afterwards gearwheel to approximately 100 C (212 F) (no more) and
remove the filter insert by lifting the plastic loop 4. Wash the press it onto the crankshaft. Note! The marking on the
filter holder clean and fit a new filter. Fit a new packing gearwheel shall face outwards. Refit the circlip on the
34.
36. Place the key in the crankshaft’s key slot. Heat the
0 0
washer 5 and refit the holder to the cover with the centre
screw.
crankshaft.
11
Categories | Volvo Penta Manuals |
---|---|
Tags | Volvo Penta MD5A |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5) Marine readers have rated Volvo Penta MD5A Marine Diesel Engine Workshop Manual 5.0 out of 5.0 based on 1 product reviews.
Very useful download. Thanks VM.