ASSEMBLING
63. Place the main bearing halves with the oil channel holes
61.
Check that the liner is not scratched and that it is in in the block. Then place the axial bearing halves in position.
good condition otherwise. Fit new 0-rings 1 in the block (2 Turn the oil grooves 1 outwards.
off) and a new 0-ring 2 on the cylinder liner. Turn the mark
on the liner (which was made during dismantling) to the mark
on the block. Lubricate the 0-rings and fit the liner. Be careful
not to damage the 0-rings.
6
2. When the cylinder liner is fitted in the block the height of 64. Oil both the bearing halves and place the crankshaft in
the liner outside the block must be measured. The height position. Fit the main bearing shells in the bearing housings
must not exceed 0,05 mm (0,0020 in.) and must not be less and place the axial bearings with the oil grooves outwards.
than 0,01 mm (0,0004 in.), otherwise there is a risk that a Fit the bearing housing so that the indentation in the housing
leak can occur.
faces the same way as the indentation in the bearing half
already in the block. Tighten the bearing housing with a
torque of 70 Nm (7 kpm) (50 Lbft.).
18
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta MD5A |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Volvo Penta MD5A Marine Diesel Engine Workshop Manual 5.0 out of 5.0 based on 1 product reviews. Very useful download. Thanks VM.