77.
Fit a plane packing and then fit the sump. Note! On 79. Replace the tappet rods and fit the rocker mechanism.
earlier engines a rubber seal was used. This is to be Check that the guide pin in the cylinder head goes into the
replaced by a plane packing. hole in the rocker mechanism.
80.
Lubricate the oil filter rubber seal. Screw in the oil filter
so far that the rubber seal first contacts the engine body.
Afterwards screw in the filter a further half turn. Note!
Tighten by hand. Then fit the feeder pump. Use a new 0-ring
between the pump and the engine.
78.
head gasket and then the cylinder head. Place the washers
under the nuts and tighten the nuts in three stages to 70 Nm
Lubricate and replace the valve lifters. Fit a new cylinder
(7
kpm) (50Lbft.). See the tightening sequence.
First stage: 10 Nm (1 kpm) (7Lbft.).
Second stage: 40 Nm (4 kpm) (29Lbft.).
Third stage: 70 Nm (7 kpm) (50Lbft.).
22
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta MD5A |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Volvo Penta MD5A Marine Diesel Engine Workshop Manual 5.0 out of 5.0 based on 1 product reviews. Very useful download. Thanks VM.