Engine body
NOTE! Make sure that the shims which were
placed under the injection pump flange are re-
placed in position before the pump is placed in the
cylinder block (applicable where the pumps has
been removed).
10.
11
Tighten the timing gear casing and injection pump.
Tightening torque: see Technical data.
Check the injection start (crankshaft position) in the
event that a new injection pump or complete new
camshaft is fitted and if a new cylinder block is
used.
Fig. 64. Fitting of timing gear casing
7.
8.
Centre the cover in front of the oil pump.
Se directions under the heading "Adjustment of in-
jection angle" on pages 55 and 56.
Note: The hole in the cover should be in the posi-
tion shown in Fig. 64 (which it should if the mark-
ings on the gear wheel coincide according to Fig.
61).
12.
Connect the fuel hose to the injection pump.
Fit the delivery pipe.
Tightening torque: see Technical data.
Place the timing gear casing in position with a new
gasket. Observe care so that the crankshaft seal is
not damaged.
Check that the start spring is in position in the tim-
ing gear casing and is connected to the regulator
arm (link arm).
Put in the regulator through the hole in the cylinder
block.
Note: Check that the tubular pip in the timing gear
casing can engage in the hole in the oil pump
cover. Turn the cover backwards and forwards and
centre it in mid position.
Fig. 66. Fitting of crankshaft pulley
13.
Put the key in position in the crankshaft and fit the
crankshaft pulley.
Tightening torque: see Technical data.
Fig. 65. Fitting of injector pump
1.
Lock pin
2. Shims
9.
Turn the stop lever clockwise and connect the arm
to the injection pump. Fit the lock pin.
43
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta MD2010, Volvo Penta MD2020, Volvo Penta MD2030, Volvo Penta MD2040 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4.25 out of 5)
Marine readers have rated Volvo Penta MD2010 MD2020 MD2030 MD2040 Workshop Manual 4.3 out of 5.0 based on 4 product reviews. GOOD AND GOODER S=GOODEST. IS BESTER
jeg skal bruge manualen , til at samle min Volvo penta md 2030 igen.
Ö, hur dka jag veta om det är bra innan jag set produkten.
Pages 58 and 59 are missing from Volvo Penta MD2010 MD2020 MD2030 MD2040 Workshop Manual. I need only these pages at present!