Engine body
9. Fit the relay box.
1
4. MD2020. MD2030. MD2040: Check and adjust if
necessary the valve clearance for cylinder No. 1,
and the clearance for the outlet valve on cylinder
No. 2.
20.
MD2O10, MD2020: Fit the alternator and clamp. Fit
the drive belt.
I
Note: It should be possible to press in the belt ap-
Pull round the crankshaft 240° (2/3 turn) anti-clock-
wise (seen from front) and adjust the clearance for
cylinder No. 3 and the clearance for the inlet valve
on cylinder No. 2.
prox. 10 mm (.40 in) between the pulleys.
21.
22.
23.
Connect the hose to the sea water pump and tigh-
ten�the clip. Connect the exhaust pipe.
Fill with refrigerant. See "Replenishment of refrige-
ra t on page 64.
Connect the battery cables. Open the fuel cocks
and bottom valve. Start the engine and check that
no leakage occurs.
5.
Clean the valve cover and fit it. Replace the seal if
damaged. Test run the engine and check that no
leakage occurs.
Adjusting the valves
Note! The clearance must never be checked when
the engine is running.
Valve clearance (cold engine):
Inlet and outlet for all engines: 0.20 mm (.0078 in).
Dismantling of piston, piston rings and
connecting rod
1.
Dismantle the valve cover.
2.
Turn the engine in its normal direction of rotation
until both valves for cylinder No. 1 are closed (com-
pression position). Continue turning the engine
1.
Empty the cooling system and drain or syphon out
the engine oil.
2.
Dismantle the cylinder head. See "Dismantling of
cylinder head" on page 25 and 26.
round until the marking of flywheel shows 0
0
.
Fig. 38. Dismantling of oil strainer with induction
manifold
Fig. 37. Adjusting the valves
3.
MD2O10: Check and adjust if necessary the valve
clearance for cylinder No. 1.
3.
Remove the sump and plate` over the sump.
Remove the oil pump�s induction manifold.
Pull round the crankshaft 180° (1/2 turn) clockwise
(see from front) and adjust the clearance for cylin-
der No. 2.
There is no plate on the MD2O10-40C.
34
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta MD2010, Volvo Penta MD2020, Volvo Penta MD2030, Volvo Penta MD2040 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4.25 out of 5)
Marine readers have rated Volvo Penta MD2010 MD2020 MD2030 MD2040 Workshop Manual 4.3 out of 5.0 based on 4 product reviews. GOOD AND GOODER S=GOODEST. IS BESTER
jeg skal bruge manualen , til at samle min Volvo penta md 2030 igen.
Ö, hur dka jag veta om det är bra innan jag set produkten.
Pages 58 and 59 are missing from Volvo Penta MD2010 MD2020 MD2030 MD2040 Workshop Manual. I need only these pages at present!