MAINTENANCE
NOTICE
When winterizing is finished, leave the
Winterization is complete when outboard shuts itself off.
outboard in vertical position long enough to com-
pletely drain the powerhead. If equipped, disconnect
the speedometer pickup at the upper connection and
blow all water out of the hose using air pressure of
172 kPa (25 psi) or less. Reconnect speedometer
pickup after all the water has been removed.
•
If the outboard DOES NOT shut itself off, you may
not have used the fast idle lever or button and the out-
board was shifted into gear.
If the engine exceeds 3000 RPM, the outboard may
have been shifted into gear.
•
In either event, immediately turn key switch OFF and re-
start the procedure.
3)
Top off oil tank.
Tiller Control Outboards
Extra engine oil is used during the winterization proce-
dure. Some excess oil may appear on the skeg below the
gearcase area. This is normal.
1)
Advance throttle grip to HALF THROTTLE position.
Start the outboard. Outboard runs at slow idle speed.
Avoid potential oil stains by placing a shop towel or suit-
able container under the propeller and skeg for the dura-
tion of the storage.
Tiller Control – Typical
2)
After outboard runs for about 15 seconds, move throttle
grip to IDLE position. Outboard continues to run at slow
idle speed.
3)
4)
After outboard runs for another 15 seconds, advance
throttle grip to HALF THROTTLE position. Outboard will
accelerate to fast idle speed and fog itself.
Allow outboard to run until it shuts itself OFF automati-
cally (less than one minute).
Winterization is complete when outboard shuts itself off.
•
If the outboard DOES NOT shut itself off, you may
not have properly advanced throttle grip.
•
If the engine exceeds 3000 RPM, the outboard may
have been shifted into gear.
In either event, immediately press STOP button to turn
outboard OFF and re-start the procedure.
After Winterization – All Outboards
1)
After the outboard shuts itself off, turn key switch OFF.
(For tiller models, remove emergency stop clip / key
switch.) Do not start the outboard again after winteriza-
tion is completed.
2)
If winterizing on a trailer, turn off water and detach
garden hose. Grease propeller shaft splines with rec-
ommended lubricant, and re-install propeller.
56
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Evinrude 40 hp, Evinrude 50 hp, Evinrude 60 hp, Evinrude PL, Evinrude RL, Evinrude SL, Evinrude TL |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Publisher | evinrude.com |
| Wikipedia's Page | Evinrude Outboard Motors |
| Copyright | Attribution Non-commercial |
(4 votes, average: 3.25 out of 4)
Marine readers have rated 2010 Evinrude 40 50 60 hp E-TEC RL TL PL SL Outboard Boat Motor Owners Manual 3.3 out of 4.0 based on 4 product reviews. This is a excellent product.i like it vey much
This is a excellent product. I like it very much
The material is very useful .use it every year
verry good to find facts about Evinrude.