X RIGGING AND ACCESSORIES
Installation
BATTERY
Slide thrust washer onto shaft with shoulder Requirements
facing aft.
Slide propeller onto shaft, engaging the
splines and seating it on the thrust bushing.
Slide spacer onto the shaft and engage the
propeller shaft splines.
•
12-volt, heavy-duty, designated for "marine"
use;
Vented/refillable or maintenance-free; and
Rated according to the minimum require-
ments in Specifications on page 51.
•
•
Wedge a block of wood between the propeller
blade and the anti-ventilation plate.
Deep-cycle batteries are suitable IF they
meet or exceed the minimum CCA require-
ments.
Install propeller nut and tighten to a torque of
120-144
in. lbs. (13.6-16.3 N·m).
Ask your Dealer about your outboard’s re-
Install keeper on propeller nut, align keeper quirements before installing longer battery ca-
slots and cotter pin hole.
bles or a battery switch.
Install new cotter pin and bend ends to se-
cure.
Installation
Remove block of wood. Make sure engine is
in NEUTRAL; give propeller a spin. It must
turn freely.
Read and understand the safety information
supplied with your battery BEFORE you begin
installation.
IMPORTANT: Make sure all components are
clean and free of corrosion.
Repair
If your propeller hits a solid object, the impact
is partially absorbed by the rubber bushing in
the hub to help prevent damage to the out-
board. A strong impact can damage the hub
and propeller blades. Damage to blades can
cause unusual and excessive vibration. Dam-
age to the hub can cause excessive engine
RPM with little forward movement.
Connect the RED (+) cable to the positive (+)
battery post first. Connect the BLACK (–) ca-
ble to the negative (–) battery post last.
If you have marine battery posts, install each
main cable on the clamp adapter with a star-
washer below it. Install all wires from acces-
sories on the threaded portion of the post.
IMPORTANT: Avoid or limit operation using a
damaged propeller. Carry a spare propeller.
Keep your propeller in good condition. Use a
file to smooth slight damage to blade edges.
See your Dealer for repair of serious damage.
1.
2.
3.
Main cable
Starwasher
Accessory wires
47
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 75 hp, Evinrude 90 hp, Evinrude PL, Evinrude PX, Evinrude WEL, Evinrude WEX |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated 2009 Evinrude 75 90 hp E-TEC PL PX WEL WEX Outboard Motor Owners Manual 5.0 out of 5.0 based on 1 product reviews. very good, had all info I needed