2009 Evinrude 75 90 hp E-TEC PL PX WEL WEX Outboard Motor Owners Manual

X OPERATION
IMPORTANT: In an emergency situation, the
engine will start and run  without the clip con-
nected  to   the   key  switch.   The  operator
should  always  use  the clip  and  lanyard
anytime  the  engine  is  running.  Refer  to
Emergency Stop/Key Switch on page 20.
WARNING
Avoid  knocking or  pulling the  clip  off
the stop switch during normal  boating.
Avoid  bumping   the  key  if   operating
without  the   clip  on  the   switch.  The
resulting  unexpected  loss  of  forward
motion  can throw  occupants  forward,
causing injury.
Move  the  remote   control  handle  to  NEU-
TRAL.
WARNING
Keep  the  lanyard   free  from  obstruc-
tions and entanglements.
If you  are using  a remote  control  that
does not have start-in-gear prevention,
the outboard  can be started  while it is
in   gear.  Protect   against  unexpected
boat movement by always starting your
outboard in NEUTRAL.
At each outing, test  the system’s oper-
ation. With the engine running, remove
the clip  from the switch  by pulling the
lanyard.  If  the  engine  does  not  stop
running, see your Dealer.
ENGINE STARTING
DO NOT advance the throttle before start-up.
Refer to  the Routine  Inspection  Checklist    Advancing the throttle overrides the electron-
on page 34 for  pre-launch checks before us-    ic idle control system. After the engine starts,
ing your Evinrude E-TEC outboard.
the engine management  module (EMM) au-
tomatically increases idle speed slightly. Idle
speed will decrease as the engine warms up.
The engine  monitor gauge  lights  or display
will illuminate if the throttle is advanced.
You MUST supply water to the engine before
attempting to start it. Engine damage can oc-
cur quickly.
Be sure  the water  intake screens are  below
the water surface.
Connect the  clip to  the emergency  stop/key
switch. Snap the lanyard to a secure place on
the  operator’s  clothing   or  life  vest  —  not
where it might tear away instead of activating
the stop switch.
Turn  the  key  switch  fully  clockwise  to  the
START position. Crank the  engine no longer
than 20 seconds.
IMPORTANT: The starter motor can be dam-
aged if operated continuously for more than
20
Upon start-up, release the key.
seconds.
1.
2.
3.
Clip
Emergency stop clip / key switch
Lanyard
21
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Tags, , , , ,
Model Year2009
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 66 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(1 votes, average: 5 out of 5)
Marine readers have rated 2009 Evinrude 75 90 hp E-TEC PL PX WEL WEX Outboard Motor Owners Manual 5.0 out of 5.0 based on 1 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

2009 Evinrude 75 90 hp E-TEC PL PX WEL WEX Outboard Motor Owners Manual SKU UPC Model
bill on Jul 03, 2018.

very good, had all info I needed


Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website