required by the indications on the dip sticks.
Refer to Table 1: “SAE Viscosity Chart” and your
engine manual included in the owner’s packet.
Follow engine manufacturer’s recommendations.
2. Turn the key switch to start and hold until engine
starts, for no longer than 10 seconds. If engine
does not start, let go momentarily, then try again.
3.
As soon as engine starts, release key to ON
or RUN.
DO NOT USE MULTIGRADE OIL. Power steering
and power trim use automatic transmission fluid.
Check the fluid levels in the vertical drive units or
transmission as often as practical.
NOTICE
Priming is not necessary for EFI engines.
Refer to the engine owner’s manual for
additional information.
THE FOLLOWING
IF THE LOWEST
SAE VISCOSITY
OILS ARE
RECOMMENDED
ANTICIPATED
TEMPERATURE IS*
3
2
O
F (0
F (-18 C) to 32
Below 0 F (-18
o
C) and above
F (0 C)
C)
SAE 30
SAE 20W-20
SAE 10W
C. Shifting and Control Speed
0
O
O
O
O
1.
Move shifter control to the neutral detent (idle)
position. This will engage neutral start switch and
allow engine to start. Move the throttle control
to the idle position.
O
O
*
Temperature range you expect to operate.
Note: Use only single viscosity oils.
Table 1: SAE Viscosity Chart
3.
Start and operate the bilge blower system for at
least four (4) minutes before start-up.
DO NOT shift into FORWARD or REVERSE
unless engine is running. Damage to the shift
system could result from trying to shift without
the engine running. Carefully check function of
all control and engine systems before leaving
the dock.
4.
Lower the vertical outdrive unit using trim switch
making sure the water intakes are under the wa-
ter.
B. Cold / Warm Engine Start (EFI Engines)
2.
3.
To go FORWARD - move the shifter control
forward.
1.
Move the control handle to neutral detent (idle)
position. The position of the control handle is
typically in the center or straight up position of the
control. See Figure A1. Notice as you push the
shifter control to the neutral position you will feel
the neutral detent engage thus indicating you are
in neutral. Note: A “start-in-neutral-only” feature
prevents starting the engine while in gear.
To go in REVERSE - move the shifter control
rearward.
NOTICE
DO NOT shift from forward to reverse when
the boat is planing.
NOTICE
DO NOT shift if engine speed is over 800 rpm.
4.
To go from FORWARD to REVERSE, or
REVERSE to FORWARD; always pause at
NEUTRAL and allow engine speed to return
to idle.
5.
After shifting is completed, move the shifter control
lever forward or rearward to increase engine
speed.
Figure A1: Throttle Control in Neutral Position
Operation - Section A
Owner’s Manual Page 18
| Categories | Four Winns Manuals, Four Winns SL-Series Manuals, Outboard Marine Corporation Manuals |
|---|---|
| Tags | Four Winns SL |
| Model Year | 2008 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)