NOTICE
ALWAYS read the manufacturer’s instructions
on the label before using any product.
I.
Brakes
Keep the actuator clean of dirt, tar, and mud. The
actuator and internal parts should be lubricated at all
times with SAE 30 weight oil. The hitch ball may be
lubricated with automotive grease or lubricant made
for hitch balls.
Periodically inspect the brake system for leaks.
Check all hoses for cuts or wear. Replace all defec-
tive hoses. The master cylinder should be filled within
1/2 inch from the top of the reservoir.
Figure S17: Turbo Lube Hub - Front Fill Model
Turbo Lube Hub Bearing Lubrication System Mainte-
nance for Front Fill models:
At the beginning of each year, inspect the brakes for
excessive wear, have linings replaced if necessary.
1.
Remove oil filling plug from Turbo Lube cap. Add
oil into the Turbo Lube hub. See Figure S18.
If the brakes need bleeding, consult your Four Winns
dealer for assistance. If unavailable, a brake or auto
repair facility can perform the repair.
Refer to the manufacturer’s literature included in
the owner’s packet for additional information on the
brake system.
J.
Bearings
Wheel bearings and seals should be inspected at the
same time as brakes. Have worn or defective parts
replaced.
Four Winns uses the Turbo Lube oil bath lubrication
system on SL model trailers. The Turbo Lube design
rotates individual roller bearings through oil multiple
times per wheel revolution. This system keeps your
hub and bearings cooler, reduces wear and increas-
es tow vehicle mileage. The Turbo Lube system is
submersible. With the Turbo Lube system the need
to disassemble hubs and repack the wheel bearings
is eliminated. See Figure S17.
Figure S18: Turbo Lube Oil Fill Diagram
2.
Add oil until oil level is just below the filler hole.
Some time should be given to allow oil to pass
through the bearings and level off.
3.
4.
Replace oil filling plug.
Check oil level. Add oil if necessary (repeating
step 1,2 & 3).
5.
Check oil level in the Turbo Lube Hub before each
trip. Add oil if required to the bottom of the filler
hole on cap.
Trailer Information - Section S
Owner’s Manual Page 140
| Categories | Four Winns Manuals, Four Winns SL-Series Manuals, Outboard Marine Corporation Manuals |
|---|---|
| Tags | Four Winns SL |
| Model Year | 2008 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)