NOTICE
NOTICE
DO NOT use a bent or damaged tongue or
coupler. Replacement parts may be ordered
through a Four Winns dealer.
When extending tongue ensure that the
brake line and wire harness are not pinched.
Failure to check could result in damage.
The trailer tongue is hinged or removable on our
painted trailers and galvanized trailers. This allows
for easier storage. The tongue is attached with clevis
pin(s) with locking hair pin(s) or clevis pin keeper(s)
to the trailer frame. Refer to Figure S3.
2.
Insert clevis pin. Always be sure to insert
clevis pin from the top and insert the clevis
pin keeper.
NOTICE
The tongue will exert some pressure on the
clevis pins. It may be necessary to lift, push or
wiggle the tongue to insert the clevis pins.
Make sure the trailer tongue is secure before
hitching to the towing vehicle.
4.
If towing the trailer, remember to plug the
5-wire
tongue harness to the trunk connector
wire harness of your tow vehicle.
C. Swivel Jack
Figure S3: Trailer Tongue Assembly
The jack is designed to lift, lower and support the
tongues of the trailers when not connected to the
towing vehicle. Before unhitching the trailer, use the
following guidelines when setting up the jack.
To pivot the tongue on trailers models with exposed
hinges:
1.
Make sure the trailer jack is supporting the trailer
load properly. Refer to Section S-2C on Swivel
Jacks for additional information.
1.
Pull on the lock pin. See Figure S4.
2.
3.
Disconnect the trailer from the tow vehicle.
Unplug the trailer’s wire harness from the tow
vehicle’s trunk connector.
Lock Pin
4.
Remove the clevis pin keeper and clevis pin.
NOTICE
The tongue will exert some pressure on the
clevis pins. It may be necessary to lift, push
or wiggle the tongue to remove the clevis pins.
Figure S4: Swivel Jack
5.
Pivot the tongue towards the trailer as far as
it will go.
2.
Swivel jack to the vertical position.
To reinstall, follow this procedure in reverse order.
3.
Release the lock pin and make sure the pin fully
1.
Pivot the tongue until the clevis pin holes
aligned.
engages the attached tongue bracket.
Trailer Information - Section S
Owner’s Manual Page 130
| Categories | Four Winns Manuals, Four Winns SL-Series Manuals, Outboard Marine Corporation Manuals |
|---|---|
| Tags | Four Winns SL |
| Model Year | 2008 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)