required by the indications on the dip sticks.
Refer to Table 1: “SAE Viscosity Chart” and your
engine manual included in the owner’s packet.
Follow engine manufacturer’s recommendations.
2. Move the throttle control(s) to the idle position
(lever(s) is all the way rearward).
3. Turn the key switch to start position and hold until
engine starts, but for no longer than 10 seconds. If
engine does not start, let go momentarily, then try
again.
DO NOT USE MULTIGRADE OIL. Power steering
and power trim use automatic trans mission fluid.
Check the fluid levels in the vertical drive units or
transmission as often as practical.
4. As soon as engine starts, release key to ON or
RUN.
THE FOLLOWING
IFTHELOWEST
SAEVISCOSITY
ANTICIPATED
NOTICE
OILSARE
TEMPERATUREIS*
RECOMMENDED
Priming is not necessary for EFI engines. Re-
fer to the engine owner’s manual for additional
information.
O
o
3
2 F(0 C)andabove
SAE30
SAE20W-20
SAE10W
O
O
O
O
0
F(-18 C)to32 F(0 C)
O
O
Below0 F(-18 C)
*Temperaturerangeyouexpecttooperate.
C. Shifting and Control Speed
Note: Useonly singleviscosity oils.
1.
Move shifter control(s) to the neutral detent (idle)
position. This will engage neutral start switch and
allow engine to start. Move the throttle control(s)
to the idle position.
Table 1: SAE Viscosity Chart
3.
4.
Start and operate the bilge blower system for at
least four (4) minutes before start-up.
Lower the vertical outdrive units using trim
switch(s) making sure the water intakes are under
the water.
DO NOT shift into FORWARD or REVERSE
unless engine is running. Damage to the shift
system could result from trying to shift without
the engine running. Carefully check function of
all control and engine systems before leaving
the dock.
B. Cold / Warm Engine Start (EFI Engines)
1.
Moving the black gaffrig shifter control(s), Figure
A1, to the center or straight up position places
the engine(s) in neutral. Notice as you push the
shifter control(s) to the neutral position you will
feel the neutral detent engage thus indicating you
are in neutral. Note: A “start-in-neutral-only” fea-
ture prevents starting the engine(s) while in gear.
2.
3.
To go FORWARD - move the shifter control for-
ward.
To go in REVERSE - move the shifter control rear-
ward.
Trim Switches Throttle Controls
Shifter Controls
NOTICE
DO NOT shift from forward to reverse when
the boat is planing.
NOTICE
DO NOT shift if engine speed is over 800 rpm.
4.
To go from FORWARD to REVERSE, or
REVERSE to FORWARD; always pause at NEU-
TRAL and allow engine speed to return to idle.
Figure A1: Gaffrig Shifter and Throttle Controls
(Twin Controls Shown)
Operation - Section A
Owner’s Manual Page 18
| Categories | Four Winns H-Series Manuals, Four Winns Manuals |
|---|---|
| Tags | Four Winns H310 |
| Model Year | 2011 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)