Product Information
Remove the cotter pin and loosen the impeller TILLER HANDLE ATTACHMENT
nut. Remove the nut, spacer, impeller, and
The tiller handle can be removed without tools
thrust bushing.
to minimize required storage space.
To attach tiller handle to the outboard:
5
•
Place shift rod through shift lever.
4
1
3
2
1
2
1.
2.
3.
4.
5.
Cotter pin
Impeller nut
Spacer
Impeller
Thrust bushing
1.
2.
Shift rod
Steering arm studs
Installation
•
Place tiller handle bracket on steering arm
studs and secure with hand nut.
Apply a small amount of Triple-Guard grease
to the impeller shaft splines. Place the thrust
bushing in the impeller and then slide the as-
sembly onto the impeller shaft.
Install the spacer on splines of the impeller
shaft.
Install and torque the impeller nut 120 to 140
in. lbs. (14 to 16 N·m).
If cotter pin holes in the impeller nut and im-
peller shaft are not aligned, continue to tight-
en the nut until they are in line. Do not loosen.
Insert a new cotter pin through the impeller
nut and shaft. Bend its ends over the nut to
secure the assembly.
1
Install the impeller housing, and following se-
quence shown, tighten screws in stages to a
torque of 70 to 100 in. lbs. (8 to 12 N·m).
1.
Hand nut
•
Install washer and retaining clip on shift rod.
1
1.
Retaining clip
42
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude MFE Manual, Evinrude Outboard Manual |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Evinrude 55 hp, Evinrude MJRL, Evinrude MRL |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Publisher | evinrude.com |
| Wikipedia's Page | Evinrude Outboard Motors |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)