2009 Evinrude 55 hp MFE MRL MJRL Outboard Boat Motor Owners Manual

Pull starter handle slowly  until starter engag-   POST-SUBMERSION SERVICING
es.  Continue  pulling  with  firm   pressure  to
When  an outboard  has been  submersed,  it
force water out of the engine.
MUST be serviced before storage.
If the outboard has been in salt water:
Run the engine  for approximately five min-
utes in fresh water at full operating temper-
ature. Refer to Flushing on p. 32.
Spray the entire  engine with fresh water to
remove salt deposits.
After five submersions,  the flywheel must be
removed and  the valley  between the  crank-
shaft   and   the   stator   windings   must   be
cleaned.
PROLONGED SUBMERSION
When the engine begins to turn freely, pull an
additional 8-20 times. This will help drain wa-
ter that might be trapped in the cylinders.
Tilt outboard to the normal running position.
Replace emergency stop clip and lanyard.
Squeeze primer bulb several times  until defi-
nite resistance is felt.
With  twist  grip in  the  slowest  position,  pull
starter handle to start engine.
The 55MFE is designed to be attached to the
back of a Zodiac  CRRC. Due to the extreme
operating conditions that this engine may ex-
perience during combat, BRP has incorporat-
ed  a  crankcase  drain  system  to  allow  the
engine to  be de-watered should  submersion
occur.
Prolonged   submersion,  or   submersion   at
depths  beyond several  feet  may cause  en-
gine damage.
After engine has run at IDLE speed for 30-60
seconds, turn  drain valves to  the RUN posi-
tion.
If prolonged  submersion occurs,  even if  the
engine  can be  started,  the engine  must be
disassembled and cleaned.
DO NOT attempt to start the outboard if sand
or silt  may have  entered the  engine. Disas-
semble and clean.
IMPORTANT: DO NOT run the outboard with
the drain valves  in the DRAIN  position more
than 3 minutes. Engine damage can result.
Continue to run under  normal operating con-
ditions (boat on plane) for at least 30 minutes
(2500
RPM or above).
IMPORTANT:  You MUST  run the  outboard
after the de-water procedure  to dry out inter-
nal moisture.
Stop engine and run the  Winterizing Proce-
dure on p. 33.
27
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude MFE Manual, Evinrude Outboard Manual
Document TypeBoat Motor Manual. Marine Operator's Engine Guide.
Tags, ,
Model Year2009
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 54 pages
Document File TypePDF
Publisherevinrude.com
Wikipedia's PageEvinrude Outboard Motors
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website