X ENGINE MONITORING
ENGINE OVERHEATING
IMPORTANT: Do not run your outboard—
even for a brief start-up—without supplying
water to it. Refer to Flushing on page 50.
While boating, the outboard’s water intakes
must stay completely submerged and unob-
structed. Observe proper transom height and
tilt angle. While the outboard is running, the
outboard’s water pump indicator must dis-
To RESET the system:
•
The engine must be shut off and the cooling
temperature restored.
IF the S.A.F.E. mode activates and the
stream from the water pump indicator be-
comes intermittent or stops, reduce speed to
idle and:
charge a steady stream of water. Check the 1) Shift to NEUTRAL.
indicator often, especially when operating in 2) SHUT OFF the engine.
weeds, muddy and debris-laden water, and at 3) Tilt the outboard up.
extreme trim angles.
4)
5)
Clean the intake screens of any blockage.
Clean the water pump indicator of any
blockage.
6)
7) Restart the engine and run at idle.
Lower the outboard.
2
IF cleaning the screens and indicator does
not restore the water pump indicator’s steady
discharge, the engine will operate only in “get
home” mode. Return to harbor immediately.
See your Dealer.
1
IF cleaning the screens and indicator does
restore the water pump indicator’s steady
discharge, you might have to run for two min-
utes in NEUTRAL to allow the engine to cool.
007031
1.
2.
Water intake screens
Water pump indicator
IMPORTANT: If cooling is not restored, the
EMM will identify a progressive overheating
condition and shut off the engine. The engine
will not restart until the engine is allowed to
cool.
RPM. If the engine was running faster than After any overheat causing engine shutdown,
RPM when the S.A.F.E. mode activat- see your Dealer for:
If the engine overheats, the S.A.F.E. (Speed
Adjusting Failsafe Electronics) mode will im-
mediately limit the engine’s speed to 1200
1200
ed, it will shake noticeably. The protection
system must be RESET before the engine will
operate at speeds over 1200 RPM. Under
certain conditions the EMM will shut off the
engine.
•
•
Inspection of the water pump for excessive
wear or damage.
Inspection of the thermostats.
IMPORTANT: Although the S.A.F.E. mode
can help prevent engine damage, it does not
guarantee you can run your engine indefinite-
ly without engine damage.
41
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 25 hp, Evinrude 30 hp, Evinrude PL, Evinrude RL, Evinrude TE, Evinrude TEL |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 5)
Marine readers have rated 2009 Evinrude 25 30 hp E-TEC RL TE TEL PL Outboard Boat Owners Manual 4.0 out of 5.0 based on 2 product reviews. I can not get an owners manual for my motor, it is an 2015 Evinrude e-tec , 2 stroke 25 hp
Thank you very much for having this service of free downloads of ETEC manuals.