Using Your E-TEC Outboard
ENGINE MONITORING
WARNING SYSTEM - S.A.F.E.
DIAGNOSTIC LEDS
This outboard is equipped with Speed Adjust- The Engine Management Module (EMM) has
ing Failsafe Electronics (S.A.F.E.).
four LED indicators located on the top corner
of the circuit board.
S.A.F.E. is an engine warning system con-
trolled by the Engine Management Module The LEDs provide quick reference to the sta-
(EMM). The EMM monitors engine sensors. If tus of several outboard systems.
conditions which could cause permanent en-
gine damage exist, the EMM limits engine
speed to 1200 RPM.
The LEDs can be used to identify specific
warning functions of S.A.F.E. mode activation
without ending a day on the water.
If engine is in S.A.F.E. mode, the outboard will
IMPORTANT: LED 1 is closest to the center
of the EMM.
shake noticeably when accelerated above
1200
RPM.
To view the LEDs the engine cover must be
removed. Refer to Removing the Engine
Cover on page 17.
For additional protection during severe oper-
ating conditions the EMM will shut OFF the
engine.
WARNING
CAUTION
The engine cover and flywheel guard
are machinery guards. Use caution
when the engine is running.
In the S.A.F.E. mode, the engine speed
is limited. Under certain conditions, the
engine’s limited speed may reduce
maneuverability of your boat.
DO NOT wear jewelry or loose clothing.
Keep hair, hands and clothing away
from rotating parts.
If the S.A.F.E. mode is activated and
you are unable to correct the problem,
seek assistance and/or return to safe
harbor. Serious engine damage, engine
shutoff, and/or reduced maneuverabil-
ity may be imminent.
2
3
1
The EMM activates S.A.F.E. mode for:
•
•
•
NO OIL warning; indicates a nearly empty
oil tank. Refer to Filling the Oil Tank and
Priming the Oil System on page 17.
OVERHEAT warning; indicates an engine
or EMM overheat condition. Refer to En-
gine Overheating on page 41.
FAULT warning; indicates a problem exists.
The EMM has identified a problem with the
outboard. Seek assistance and/or return to
harbor immediately. See your Dealer.
007056
1.
2.
3.
EMM
LEDs
LED 1
The LEDs identify system functions in two
modes, Start Mode and Running Mode.
As the outboard is being started, all four LEDs
should light and then go OFF in sequence.
When the outboard is running, all LEDs
should be OFF.
38
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 25 hp, Evinrude 30 hp, Evinrude PL, Evinrude RL, Evinrude TE, Evinrude TEL |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 5)
Marine readers have rated 2009 Evinrude 25 30 hp E-TEC RL TE TEL PL Outboard Boat Owners Manual 4.0 out of 5.0 based on 2 product reviews. I can not get an owners manual for my motor, it is an 2015 Evinrude e-tec , 2 stroke 25 hp
Thank you very much for having this service of free downloads of ETEC manuals.