Maintenance: Laying up and launching
Bringing out of storage
●
Check oil level in the engine and drive/reverse
gear. Top up if necessary. If there is inhibiting oil
in the system drain and fill with new oil, change oil
filter. For correct oil grade: See the chapter ”Tech-
nical Data”.
● Paint the drive and hull: See next page.
● Check the sacrificial anode on the drive. If there is
less than 50% of the anode left it must be re-
placed. Clean with emery cloth just before the boat
is launched.
●
●
Drain the antifreeze from the seawater system.
IMPORTANT! Do not use a wire brush or other
steel tools when cleaning, as these may damage
the galvanic protection.
Install the impeller in the seawater pump (replace if
the old one looks worn).
●
●
●
Close/tighten drain cocks/plugs.
Check drive belts.
●
●
●
Reinstallthepropeller.
Launch the boat. Check for leaks.
Check the condition of rubber hoses and tighten
hose clamps.
Vent and lubricate the propeller shaft seal (reverse
gear).
●
●
Check engine coolant level and antifreeze protec-
tion. Top up if necessary.
●
Start the engine. Check that there are no fuel,
engine coolant or exhaust gas leaks and that all
control functions are operating.
Connect the fully charged batteries.
53
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta D1-13, Volvo Penta D1-20, Volvo Penta D1-30, Volvo Penta D2-40 |
| Model Year | 2005, 2006, 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)