Maintenance: Engine, general
Air Cleaner (ACL). Changing
Loosen the hose clamp (1) and screw (2) to remove
the old filter.
1
Fit the new filter and tighten the hose clamp.
IMPORTANT! Take care that no contaminants
entertheengine.
2
Idling. Adjustment
For engine idling speed: Please refer to the Technical
Data chapter. A lower engine speed can cause the
engine to stall and a higher engine speeds can cause
extra stresses to the drive/reverse when shifting.
A
B
C
Adjust with the engine at operating temperature as
follows:
1*
Set the control lever in the neutral position. Check
that gap (A) is approx. 3 mm. Adjustment: Slacken
off the locknut (B) and adjust until the correct gap
is obtained with screw (C). Tighten the locknut.
*This point does not apply to boats with double control
positions.
2
Start engine and allow to idle with gear selector in
neutral.
D E
WARNING!Approachingorworkingonarunning
engine is dangerous. Watch out for rotating
components and hot surfaces.
3
Slacken off locknut (D). Adjust engine speed with
adjustment screw (E). Tighten the locknut. Repeat
step 1.
29
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta D1-13, Volvo Penta D1-20, Volvo Penta D1-30, Volvo Penta D2-40 |
| Model Year | 2005, 2006, 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)